Runco LIGHTSTYLE LS-HB Manual de usuario descargar pdf (Pagina 83)

Operation

Runco LS-HB Installation/Operation Manual 67

PRE

IMINAR

• RS232 causes the port to output 12 volts when an RS232 screen trigger 1 “on”

command is received and stop when a trigger 1 “off” command is received. The 12 volt

output also stops when the projector is turned off.

Remote Code Set: Select Remote Code Set from the Control menu to specify the

remote IR code set to which the LS-HB responds. The default is Set-1. Choose Set-2 if

other equipment in the theater responds to commands from the LS-HB remote control in

ways that are unexpected or undesirable.

When you select a different remote code set on the LS-HB, you must re-program the

remote control unit to use that same code set. To do this, press and hold the LIGHT and

ENTER buttons simultaneously for approximately five seconds. When the code set has

changed, the remote control back-lighting “blinks” to visually confirm the change.

Table 6-1 lists the IR codes associated with each remote control button.

Auto Source: This control chooses whether or not to scan for other active sources if the

current source is not available. The default setting is Off.

LanguageSelect Language from the Main Menu to change the OSD Language.

The LS-HB can display the menus in English, French, German, Italian, Spanish, Swedish,

Traditional Chinese, Simplified Chinese, Japanese, Korean, Portuguese or Russian.

Press or to select a language. Then, press ENTER to confirm your selection.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 109 110

Sin comentarios

Runco LIGHTSTYLE LS-HB Manual de usuario Pagina 83