Runco Q-750d Ultra Series Especificaciones Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 134
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
Installation
14 Q-750d Ultra Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the Q-750d Ultra installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 15
2
Install primary projection lens 21
3
Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
24
4
Mount the projector 30
5
Connect the DHD Controller to the projector 31
6
Connect signal sources to the DHD Controller 33
7
Connect other external equipment to DHD Controller
(optional):
Audio processor or secondary display device
Automation/control system (RS-232)
12-volt trigger-activated equipment (AutoScope lens
motor, retractable screens or screen masking etc.)
External IR repeater
Network hub, router or gateway (Ethernet)
39
8
Connect projector, DHD Controller and lens motor (if
present) to AC power and power up
42
9
Adjust primary lens: projected image size (zoom), position
(shift) and focus; copy and paste settings as needed
18, 44
10
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
44
11
Use Image Alignment controls to fine-tune image geometry 45
12
Install and adjust CineWide anamorphic lens (optional) 47
13
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
55
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 133 134

Comentarios a estos manuales

Sin comentarios