Runco QUANTUM COLOR Q-750I Especificaciones descargar pdf (Pagina 56)

Installation

40 Q-750i Series Installation/Operation Manual

PRE

IMINAR

Adjusting the Pitch (Angle): Next, angle the lens to even out any top-to-bottom

pincushion distortion. To do this, loosen the Pitch Adjustment T-Screws (directly below

the Height/Y Adjustment T-Screws) on either side of the lens to allow it to pivot freely.

Then, adjust the anamorphic lens angle so that the projected image is rectangular:

The anamorphic lens will almost always be angled with respect to the projector; this is

normal.

Once the proper lens angle has been set, firmly tighten the Pitch Adjustment T-Screws to

secure the lens in place.

Adjusting the Yaw: Loosen the Yaw/X-Adjustment Levers to allow the lens to pivot freely

from side to side. Then, angle the lens to even out any left-right pincushion distortion:

There may be some pincushion distortion even after the lens is

properly adjusted, especially at shorter throw distances. If this is the

case, Runco recommends that you slightly over-scan the image

into the screen frame area to mask the distortion.

Correct Lens Angle

Incorrect Lens Angle

Note

Anamorphic Lens (Top View)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 107 108

Sin comentarios

Runco QUANTUM COLOR Q-750I Especificaciones Pagina 56