Runco VX-60d Especificaciones Pagina 102

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 101
Maintenance and Troubleshooting
86 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
The display is jittery or
unstable.
Poor-quality or improperly
connected source.
The horizontal or vertical
scan frequency of the
input signal may be out of
range for the projector.
Ensure that the source is
properly connected and of
adequate quality for
detection.
Correct at the source.
Image is too bright and/or
lacks definition in the bright
areas of the image.
Contrast is set too high. Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright.
Brightness is set too high. Lower the brightness
setting.
Colors in the image are
swapped; for example, reds
appear blue or vice versa.
The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
DHD Controller.
Ensure that the source
outputs are connected to
the correct DHD Controller
input.
The display freezes suddenly. Excessive voltage noise on
the AC or ground input has
interrupted the projector’s
ability to lock on to a
signal.
Power down the projector
and disconnect from AC.
Then, plug in again and
power up as usual.
The projector will not turn
back on after it was powered
down, or the image disap-
pears during operation.
The projector will not turn
on for two minutes after
power-down, to protect
the lamp.
The lamp has failed.
Wait until the
STANDBY LED at the front
of the DHD Controller
turns on (Figure 2-3).
Replace the lamp.
AutoScope lens motor does
not work.
The motor is not plugged
in or the AC outlet is not
active.
The motor is not
connected to a trigger
output on the DHD
Controller.
Incorrect trigger
assignment.
Ensure that the motor is
plugged in and that the AC
outlet is active.
Check the trigger
connection between the
lens motor and DHD
Controller (Figure 3-17).
Correct the trigger
assignment (refer to
Installing and Adjusting
the CineWide
Anamorphic Lens on
page 45).
Table 5-1. Troubleshooting Chart (continued)
Symptom Possible Cause(s) Solution
Vista de pagina 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 125 126

Comentarios a estos manuales

Sin comentarios

Kenwood KDC-3026R manuals

Owner’s manuals and user’s guides for Car media receivers Kenwood KDC-3026R.
We providing 1 pdf manuals Kenwood KDC-3026R for download free by document types: User Manual






More products and manuals for Car media receivers Kenwood

Models Document Type
DNN991HD Instruction Manual   Kenwood DNN991HD Instruction Manual, 178 pages
DDX 5022 Y Instruction Manual   Kenwood DDX 5022 Y Instruction Manual, 96 pages
KDC-BT7539U User Manual   Kenwood KDC-BT7539U User's Manual, 40 pages
KDC-348U User Manual     Kenwood KDC-348U User's Manual, 112 pages
KDC-5051U User Manual    Kenwood KDC-5051U User's Manual, 59 pages
KDC-105U User Manual     Kenwood KDC-105U User's Manual, 32 pages
KRC-6901R User Manual    Kenwood KRC-6901R User's Manual [en] , 38 pages
KDC-4051UR User Manual   Kenwood KDC-4051UR User's Manual, 21 pages
DDX 9902 S User's Guide   Kenwood DDX 9902 S User Guide, 80 pages
DDX 6054 Instruction Manual   Kenwood DDX 6054 Instruction Manual, 96 pages
KDC-8021 User Manual   Kenwood KDC-8021 User's Manual, 52 pages
KDC-X7529 User Manual   Kenwood KDC-X7529 User's Manual, 38 pages
DNX571HD Instruction Manual   Kenwood DNX571HD Instruction Manual, 145 pages
KDC-W3537 User Manual    Kenwood KDC-W3537 User's Manual, 36 pages
KDC-X7533U User Manual   Kenwood KDC-X7533U User's Manual, 40 pages
Excelon KVT-915DVD User Manual   Kenwood Excelon KVT-915DVD User's Manual, 57 pages
KDC-U546BT User Manual    Kenwood KDC-U546BT User's Manual, 74 pages
KDC-237 User Manual   Kenwood KDC-237 User's Manual, 28 pages
H2EV User Manual   Kenwood H2EV User's Manual, 17 pages
CD-RECEIVER KDC-5070R User Manual    Kenwood CD-RECEIVER KDC-5070R User's Manual, 40 pages