Runco VX-8d Especificaciones Pagina 86
- Pagina / 104
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Maintenance and Troubleshooting
70 Runco VX-8d Installation/Operation Manual
PRE
L
IMINAR
Y
5.2
Troubleshooting Tips
Table 5-1 provides some general guidelines for troubleshooting problems you may
encounter with the VX-8d. If you encounter an issue not described here, please contact
Runco Technical Support.
Table 5-1. Troubleshooting Chart
Symptom Possible Cause(s) Solution
The projector does not turn
on after initial installation. The
power LED on the front of the
DHD Controller lights red after
you press the power button.
• The DHD Controller is
connected to the VX-8d
incorrectly or not at all.
• The VX-8d is not plugged
in or the AC outlet is not
active.
• Verify the HDMI-DVI cable
connection from the DHD
Controller to the VX-8d.
• Ensure that the VX-8d is
plugged in and that the AC
outlet is active.
The projector and DHD Con-
troller are both on, but there is
no video image on-screen.
• Incorrect source selection.
• Source component is not
turned on.
• Select the correct source.
• Turn on the source.
Image is too bright and/or
lacks definition in the bright
areas of the image.
• Contrast is set too high. • Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright.
• Brightness is set too high. • Lower the brightness
setting.
Colors in the image are
swapped; for example, reds
appear blue or vice versa.
• The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
DHD Controller.
• Ensure that the source
outputs are connected to
the correct DHD Controller
input.
Image geometry is incorrect. • Incorrect aspect ratio
selection.
• Select the aspect ratio that
best matches the source
image and screen size
(refer to
Table 4-1).
The projector will not turn
back on after it was powered
down, or the image disap
-
pears during operation.
• The projector will not turn
on for two minutes after
power-down, to protect
the lamp.
• The lamp has failed.
• Wait two minutes until the
LED at the front of the
DHD Controller turns red.
• Replace the lamp.
- NSTALLATION/OPERATION MANUAL 1
- Warranty 3
- Important Safety Instructions 7
- Compliance Information 8
- Table of Contents 11
- List of Figures 15
- 1. Introduction 17
- Using This Manual 18
- Description, Features 19
- Introduction 20
- 2. Controls and Functions 21
- Controls and Functions 22
- VX-8d Rear Panel 23
- DHD Controller Front 24
- DHD Controller Rear 25
- VX-8d Remote Control 27
- 3. Installation 31
- Quick Setup 32
- Installation 33
- Considerations 33
- Estimating Throw Distance 34
- Screen width (w) 34
- Ceiling Installation 36
- Floor Installation 36
- Installing the Optional 39
- CineWide Lens Mount 39
- (page 28) 42
- Mounting the VX-8d 44
- Connections to the 45
- VX-8d and DHD 45
- Controller 45
- DTV-Set-Top Box 48
- (DTV-STB) 48
- RGB Camcorder 49
- Figure 3-15 50
- Gaming Console 51
- Camcorder 51
- Control System 52
- AutoScope Lens Motor (Rear) 53
- IR Sensor 54
- IR Repeater 54
- Remote Control 54
- Aspect Ratio 55
- Input Resolution/Frame Rate 55
- Installing and 57
- Adjusting the 57
- CineWide Anamorphic 57
- Too Far Right 59
- Too Far Left 59
- Correct position 59
- Too High 60
- Correct Lens Angle 60
- Incorrect Lens Angle 60
- Anamorphic Lens (Top View) 61
- Using the On-Screen 63
- Gamma 2.0, 2.1, 2.2, 2.4, 2.5 63
- Chroma Delay 63
- ➡ Composite 65
- 4:3 Image on 66
- 16:9 Display 66
- (Letterbox aspect ratio) 66
- 1080i HDTV Image 67
- 720p HDTV Image 67
- Below Black 68
- Operation 69
- No Overscan Crop Zoom 73
- Lamp Replacement 85
- Troubleshooting Tips 86
- 6. Serial Communications 87
- Table 6-1. Serial Commands 88
- Serial Communications 92
- 7. Specifications 93
- DHD Controller 95
- VX-8d Dimensions 96
- VX-8d/CineWide 97
- Dimensions 97
- VX-8d/CineWide with 98
- AutoScope Dimensions 98
- Supported Timings 99
- Specifications 102
- SERIAL NUMBER 104
Relacionado con productos y manuales para Proyectores de datos Runco VX-8d
Proyectores de datos Runco VX-2c Guia de preparacion
(36 paginas)
(36 paginas)
Proyectores de datos Runco CL-500 Manual de usuario
(32 paginas)
(32 paginas)
Proyectores de datos Runco XP-103DHD Especificaciones
(126 paginas)
(126 paginas)
Proyectores de datos Runco VX-4000d Especificaciones
(108 paginas)
(108 paginas)
Proyectores de datos Runco VX-2i Especificaciones
(112 paginas)
(112 paginas)
KIA Sorento (2011) podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Samochody KIA Sorento (2011).
Dostarczamy 1 pdf podręczników KIA Sorento (2011) do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentarios a estos manuales