Runco XtremeProjection X-200i Especificaciones descargar pdf (Pagina 39)

Installation

Runco X-200i Series Installation/Operation Manual 23

PRE

IMINAR

3.4

Installing the Optional

CineWide Lens Mount

If you are installing a standard (non-CineWide) X-200i, skip this step and proceed with

Mounting the X-200i (page 28).

If you are installing an X-200i/CineWide with a “McKinley” (cylindrical)

anamorphic lens, proceed with

Installing the Fixed CineWide Base

Plate (Cylindrical Anamorphic Lens) (page 27).

If you are installing an X-200i/CineWide with a “Whitney” (prismatic)

anamorphic lens, proceed with

Installing the Fixed CineWide Base

Plate (Prismatic Anamorphic Lens) (page 26).

If you are installing an X-200i/CineWide with AutoScope, proceed as follows to install the

AutoScope lens motor.

Remove Projector Feet: Place the

projector upside down on a blanket or

other soft surface. Loosen and remove

the two front feet on the projector.

1. Do not install the CineWide lens yet, only the fixed CineWide

base plate or AutoScope lens motor. You will install the

CineWide lens after you install the projector and adjust the

primary lens.

2. Some components shipped with your projector may differ slightly

from what is shown in these instructions.

Note

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 117 118

Sin comentarios

Runco XtremeProjection X-200i Especificaciones Pagina 39