Runco VX-6c Manual de usuario descargar pdf (Pagina 23)

INSTALLATION AND SETUP

 J1 jumper: For either remote, set between pins 1 and 2 to set as Protocol “A”. Set between

pins 2 and 3 to set as Protocol “B”.

 J2 jumper: For either remote, set between pins 2 and 3 as shown; otherwise, the projector

will not respond correctly to keypad commands.

 J3 jumper: For the IR remote, make sure that the jumper is set between pins 2 and 3 as

shown. For the wired remote, make sure that the jumper is set between pins 1 and 2 as

shown.

 J4 jumper: For the IR remote, make sure that the jumper is set between pins 1 and 2 as

shown. For the wired remote, make sure that the jumper is set between pins 2 and 3 as

shown.

Step 5

Replace battery compartment cover. Plug into projector (wired keypad only) and test.

Locating and Setting the Jumpers

NOTE: A wired keypad can be converted into an IR remote keypad, and vice versa. Follow the

settings shown above, adding or deleting the cable and batteries as required. The cable with 3-

pin XLR connector is available separately from your dealer.

2-16

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

Sin comentarios

Runco VX-6c Manual de usuario Pagina 23