
22
DVI Digital Video ➤
INPUT 3 and INPUT 4 provide simultaneous connection of both a composite video
source (INPUT 3) and an S-Video source (INPUT 4), though typically these connections
would be made at the DHD Controller. See Figure 2.12.
Use the DVI-I connector at INPUT 2 to connect either analog or digital video devices to
the projector. The DHD Controller can be input here as well; adjust the output setting of
the DHD Controller to DVI if use of this port is desired. Use a cable with DVI-I connectors
at both ends to connect devices that transmit digital and analog video signals such as
high-quality DVD players, satellite receiver and digital cable TVs.
NOTE: 1) To ensure true digital output from devices that transmit digital signals, connect
to the DVI-I connector. 2) DVI loop through is not available unless you have the optional
DVI Input Module installed at INPUT 5 or INPUT 6.
Contact Runco for available optional input modules.
Figure 2.12 Connecting Composite or S-Video sources
Composite and S-Video ➤
Optional Inputs ➤
Section 2: Installation and Setup Section 2: Installation and Setup
Comentarios a estos manuales