Runco VX-60d Especificaciones Pagina 85
- Pagina / 126
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Operation
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 69
PRE
L
IMINAR
Y
The Auto Color Enable and Test Pattern Enable checkboxes let you choose what to
display on-screen while making these adjustments. These controls work together as
follows:
•Lamp: Select Lamp from the Display Color - Projector Settings menu to adjust the
projector lamp brightness.
• Power: To supply a constant wattage to the lamps, select Power from the Lamp
menu to set the lamp power level. You can choose to run the lamps as bright as
possible (this is the default setting) or you can choose a lower setting. Generally,
lower lamp output prolongs the life of a lamp, but decreases brightness.
• SatCo (Yellow Notch Filter): Select SatCo from the Display Color - Projector
Settings menu to enable (Off) or disable (On) the yellow notch filter in the projector. The
Off setting produces a wider color gamut, while the On setting produces higher
brightness.
Auto Color Enable
Setting
Test Pattern Enable
Setting
Description
Off Off When both boxes are unchecked, the input
signal (normal picture) appears on the
display.
Off On When only the Test Pattern Enable box is
checked, a white “curtain” test pattern
appears instead of the input signal.
On Off When only the Auto Color Enable box is
checked, the input signal appears on the
display.
When you select a red, green or blue color
point to adjust, the DHD Controller displays
only that color channel. When you select a
white point x- or y-value, all colors are
visible (normal picture).
On On When both boxes are checked, the DHD
Controller automatically displays a red,
green, blue or white “curtain” test pattern
when you select an x- or y-value for that
color point to adjust.
The Lamp Power setting affects both lamps.
Note
- SC-50d Series 1
- SC-60d Series 1
- Warranty 3
- Important Safety Instructions 7
- Compliance Information 8
- Table of Contents 11
- List of Figures 15
- 1. Introduction 17
- Using This Manual 18
- Description, Features 19
- Introduction 20
- 2. Controls and Functions 21
- SC-50d/SC-60d Input 22
- Controls and Functions 23
- DHD Controller Front 24
- DHD Controller Rear 25
- Remote Control Unit 27
- 3. Installation 31
- Quick Setup 32
- Installation 33
- Considerations 33
- Estimating Throw Distance 34
- Throw Distance (TD) = 34
- Ceiling Installation 35
- Floor Installation 35
- Installing the Primary 41
- Projection Lens 41
- Installing the Optional 42
- AutoScope Lens Motor 42
- Mounting the 43
- Connections to the 45
- SC-50d/SC-60d and 45
- Figure 3-14 50
- Audio Processor/ 52
- Switcher 52
- Secondary Display 52
- Control System 53
- IR Sensor 55
- IR Repeater 55
- Remote Control 55
- Ferrite sleeveAC power cord 56
- To power outlet 56
- To Projector AC IN 56
- Turning on the Power 57
- Adjusting the Image 59
- Geometry 59
- Installing and 61
- Adjusting the 61
- CineWide Anamorphic 61
- Too Far Right 63
- Too Far Left 63
- Correct position 63
- Too High 64
- Correct Lens Angle 64
- Incorrect Lens Angle 64
- Anamorphic Lens (Top View) 65
- Working With the 66
- 4. Operation 67
- Operation 68
- 4:3 Image on 70
- 16:9 Display 70
- (Letterbox aspect ratio) 70
- 1080i HDTV Image 71
- 720p HDTV Image 71
- Below Black 73
- 7 Auto Color Enable 84
- 7 Test Pattern Enable 84
- Input Names 90
- Lamp Compartment Cover 99
- Retaining Screws 99
- Troubleshooting Tips 101
- 6. External Control 103
- Table 6-1. Serial Commands 104
- Using Discrete IR 108
- Start Bits Toggle Bit 109
- Address Bits Command Bits 109
- 11010001000001 109
- Using HDMI CEC 112
- Messages 112
- External Control 114
- 7. Specifications 115
- DHD Controller 117
- Specifications 117
- SC-50d/SC-60d 119
- Dimensions 119
- Dimensions with 120
- CineWide with 120
- AutoScope Assembly 120
- Supported Timings 121
- 020-1105-01 Rev. A 126
- July 2011 126
Relacionado con productos y manuales para Proyectores de datos Runco VX-60d
Proyectores de datos Runco DR-300c Manual de usuario
(36 paginas)
(36 paginas)
Proyectores de datos Runco CL-420 Especificaciones
(72 paginas)
(72 paginas)
Proyectores de datos Runco RS-440LT Especificaciones
(41 paginas)
(41 paginas)
Proyectores de datos Runco VX-8d Especificaciones
(104 paginas)
(104 paginas)
Proyectores de datos Runco VX-2c Guia de preparacion
(36 paginas)
(36 paginas)
Proyectores de datos Runco CL-500 Manual de usuario
(32 paginas)
(32 paginas)
Proyectores de datos Runco XP-103DHD Especificaciones
(126 paginas)
(126 paginas)
Proyectores de datos Runco VX-4000d Especificaciones
(108 paginas)
(108 paginas)
Proyectores de datos Runco VX-2i Especificaciones
(112 paginas)
(112 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales