Runco CL-410 Especificaciones descargar pdf (Pagina 18)

Using the Adjustment

Feet

The height of the projector can be adjusted using the adjustment feet. This is useful for

correcting the angle of the projection when the projector is placed on an uneven surface

or when the screen is slanted. The adjustment feet are connected to threaded bolts, which

can be turned in to shorten or out to lengthen.

1 Lift the side of the projector you would like ti raise

or lower.

2 Turn the adjustment feet to shorten or lengthen. If

the screen is at an angle, the adjustment feet can

be set higher than the rear adjustment feet to set

the image at an angle.

3 Return the projector to the original

position.

Connection and Setup



Note:

• When lowering the projector, be careful not to get your finger caught in the

area between the adjustment foot and the projector.

• The projector is adjustable up to approximately 5 degrees from the standard

position.

• When the height of the projector is adjusted, the image may become distorted

(keystone distortion). See “Keystone” on page 44 for details on keystone

correction.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 56 57

Sin comentarios

Runco CL-410 Especificaciones Pagina 18