Runco VX-3C Especificaciones descargar pdf (Pagina 20)

2-14

INSTALLATION AND SETUP

Composite Video!

The video decoder input panel provides simultaneous connection of both a composite video

source (INPUT 3) and an S-Video source (INPUT 4).

If connecting a composite video source, use the Composite BNC connector or the RCA phono

jack at -do not use both as inputs. See Figure 2.13.

AUDIO for INPUT 3: To control audio levels in an audio/visual system, connect pre-amplified

(line level) audio inputs to the “IN 3” left and right channel audio inputs located near the top

left corner of the rear input panel. Then connect external audio amplification equipment to

audio “OUT” for sound output. Audio connection cables require standard RCA type phono

plugs.

NOTE: If you want to loop a composite video signal through to another projector or display

device, see Video Loop Through later in this section.

Figure 2.13. Connecting Composite Video

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 128 129

Sin comentarios

Runco VX-3C Especificaciones Pagina 20