Runco VX-3C Especificaciones descargar pdf (Pagina 33)

2-27

INSTALLATION AND SETUP

! J1 jumper: For either remote, set between pins 1 and 2 to set as Protocol “A”. Set between

pins 2 and 3 to set as Protocol “B”.

! J2 jumper: For either remote, set between pins 2 and 3 as shown; otherwise, the projector

will not respond correctly to keypad commands.

! J3 jumper: For the IR remote, make sure that the jumper is set between pins 2 and 3 as

shown. For the wired remote, make sure that the jumper is set between pins 1 and 2 as

shown.

! J4 jumper: For the IR remote, make sure that the jumper is set between pins 1 and 2 as

shown. For the wired remote, make sure that the jumper is set between pins 2 and 3 as

shown.

Step 5

Replace battery compartment cover. Plug into projector (wired keypad only) and test.

Figure 2.26. Locating and Setting the Jumpers

NOTE: A wired keypad can be converted into an IR remote keypad, and vice versa. Follow the

settings shown above, adding or deleting the cable and batteries as required. The cable with 3-

pin XLR connector is available separately from your dealer.

SHORTCUT METHOD:

You can also issue software protocol settings through the keypad. These software commands

will be lost when the keypad is either unplugged or when a battery is removed - the keypad will

revert back to the hard-wired jumper settings (see above) until you enter the software com-

mands again.

Press = Protocol “A”

Press = Protocol “B”

Input1

Color

Pixel

Position 1

Input1

Color

Pixel

Position 2

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 128 129

Sin comentarios

Runco VX-3C Especificaciones Pagina 33