Runco REFLECTION Especificaciones Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Installation
14 Runco RS-1100 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the RS-1100 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 15
2
If installing an RS-1100 Ultra/CineWide with
AutoScope: Install AutoScope lens motor (optional)
21
3
Mount the projector 24
4
If installing with an SDC-1, connect ONLY the SDC-1
output to the RS-1100 and make all other connections to
the SDC-1; continue with Step 7
-- OR --
If installing without an SDC-1, connect signal sources to
the RS-1100 and continue with Step 5
26
5
Connect external controller to RS-232 port (optional) 29
6
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional)
30
7
Apply power to the projector 31
8
Change the OSD Language (optional) 32
9
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
32
10
Primary lens adjustments: projected image size (zoom),
position (shift) and focus
18, 32
11
Install CineWide anamorphic lens (optional) 33
12
CineWide lens adjustments: position, pitch (angle),
geometry and focus
35
13
Projector calibration: adjust the following for each input,
starting with Component 1; save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
51 through 59
Note
Downloaded From projector-manual.com Runco Manuals
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 91 92

Comentarios a estos manuales

Sin comentarios