Runco REFLECTION Especificaciones Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
Installation
22 Runco RS-1100 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Remove Projector Front
Feet
Place the projector upside down on a blanket
or other soft surface. Then, remove the two
front feet by turning them counter-clockwise.
Install Anamorphic Lens
Motor
Line up the eight mounting holes on the lens motor housing with those on the bottom of
the projector. Secure the motor to the projector with the eight screws provided for this
purpose, as shown in
Figure 3-6.
Figure 3-6. RS-1100 Ultra with AutoScope Lens Motor – Bottom View
The anamorphic lens mounting kit is partially pre-assembled at the
factory – the AutoScope lens motor and lens mounting assemblies
are both fully assembled.
DO NOT OVER-TIGHTEN THE SCREWS.
Note
Caution
Downloaded From projector-manual.com Runco Manuals
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 91 92

Comentarios a estos manuales

Sin comentarios