Runco XtremeProjection X-450d Especificaciones Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 156
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
System Overview
Runco X-400d/X-450d Installation/Operation Manual 7
PRE
L
IMINAR
Y
1. PROJECTION LENS
The inside of the lens barrel is threaded to accommodate a standard, 72-mm lens
filter. For example, with a smaller screen you can install a neutral-density filter to
reduce the overall light output.
2. RUNCO LOGO
The logo can be rotated to match the projector orientation: inverted (ceiling-mounted)
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
3. EXHAUST VENT
Warm air exits the projector through this vent. Ensure that it is not blocked.
4. INTAKE VENT
Internal fans draw cool air into the projector through this vent.
5. CEILING MOUNTING HOLES
Use these to attach the ceiling bracket (if needed) to the projector.
6. CABLE OPENING
Pass cables through this opening.
2.2
X-400d/X-450d Rear
Panel
Figure 2-3 shows the X-400d/X-450d rear panel.
Figure 2-3. X-400d/X-450d Rear Panel
1. RS232 (Control)
A female, 9-pin D-sub connector that provides a serial communication link to the
Dimension Digital Controller, via its Pri. Display Control output (see Figure 2-5).
2. 3D LED
Lights green when the projector is displaying 3D content.
RS232
RS232
PRIMARY
PRIMARY
SECONDARY
SECONDARY
1 2 3 4 65 7
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 155 156

Comentarios a estos manuales

Sin comentarios