Runco XtremeProjection X-450d Especificaciones Pagina 75
- Pagina / 156
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Installation
Runco X-400d/X-450d Installation/Operation Manual 59
PRE
L
IMINAR
Y
Adjusting the Lens Height and Angle:
1. Project a white field on the screen.
2. Loosen the four Height/Pitch Adjustment Screws just enough to allow vertical
movement of the lens assembly.
3. Slowly move the anamorphic lens into place so that there are no shadows on the top
or bottom of the screen:
4. Then, adjust the anamorphic lens angle so that the projected image is rectangular:
The anamorphic lens will almost always be angled with respect to the projector; this is
normal.
5. When the height and angle are properly set, tighten the Height/Pitch Adjustment
Screws to secure the lens in place.
There may be some pincushion distortion even after the lens is
properly adjusted, especially at shorter throw distances. If this is the
case, Runco recommends that you slightly over-scan the image into
the screen frame area to mask the distortion.
Too High
Too Low
Correct position
Correct Lens Angle
Incorrect Lens Angle
Note
- XtremeProjection™ Series 1
- X-400d and X-450d 1
- Warranty 3
- Important Safety Instructions 7
- Compliance Information 9
- Table of Contents 11
- List of Figures 15
- 1. Introduction 17
- Using This Manual 18
- Description, Features 19
- Introduction 20
- 2. System Overview 21
- Projector 22
- 1 2 3 4 65 7 23
- DC-300 Dimension 24
- Digital Controller 24
- System Overview 25
- Remote Control Unit 28
- X-400d/X-450d Active 32
- 3D Emitter 32
- 3. Installation 33
- Quick Setup 34
- Installation 35
- Considerations 35
- Estimating Throw Distance 36
- Throw Distance (TD) = 36
- Screen width (w) 36
- Ceiling Installation 38
- Floor Installation 38
- Installing the Optional 42
- CineWide Lens Mount 42
- Mounting the 48
- Interconnections 50
- Dimension Digital Controller 51
- Audio Processor/ 52
- Switcher 52
- Secondary Display 52
- (to ctrl. system) 53
- (from ctrl. system) 53
- AutoScope Lens Motor 54
- Notebook Computer 57
- HDMI source 58
- COMPONEN T 59
- VIDEO OUT 59
- Computer 60
- Gaming Console 61
- DVD/DTV STB 61
- Camcorder 62
- Active 3D Emitter 63
- Turning on the Power 64
- Adjusting the Image 66
- Geometry 66
- Installing and 68
- Adjusting the 68
- CineWide Anamorphic 68
- Lens threads into ring 70
- Too Far Right 71
- Too Far Left 71
- Correct position 71
- Too High 72
- Anamorphic Lens (Top View) 73
- Correct Lens Angle 75
- Incorrect Lens Angle 75
- Wrong Position 76
- Correct Position 76
- 4. Operation 77
- 4:3 Image on 81
- 16:9 Display 81
- (Letterbox aspect ratio) 81
- 1080i HDTV Image 82
- 720p HDTV Image 82
- Below Black 84
- 3D Processing 91
- Reverse Eyes 91
- 7 Auto Color Enable 96
- 7 Test Pattern Enable 96
- Operation 100
- Primary Alignment 102
- Input Names 103
- SRC 1 Key 105
- Power Button 114
- Battery Status 114
- LED (Red/Blue) 114
- Lamp Replacement 117
- Troubleshooting Tips 118
- 6. External Control 121
- External Control 122
- Table 6-1. Serial Commands 123
- DBO R/W Yes -100 100 No 125
- DGO R/W Yes -100 100 No 126
- DRO R/W Yes -100 100 No 126
- IBO R/W Yes -32 32 No 127
- IGO R/W Yes -32 32 No 128
- IRO R/W Yes -32 32 No 129
- SHO R/W Yes -50 50 No 134
- (VSH+) or (VSH-) to 137
- (ZOM+) or (ZOM-) to 137
- Using Discrete IR 138
- (Standard Mode) 139
- (Standard Mode) (continued) 140
- (Extended Mode) 142
- Controller 143
- (continued) 144
- 7. Specifications 145
- Dimension Digital 148
- Specifications 148
- Supported Timings 150
- X-400d/X-450d 154
- Dimensions 154
- 020-1203-00 Rev. A 156
- September 2012 156
Relacionado con productos y manuales para Proyectores de datos Runco XtremeProjection X-450d
Proyectores de datos Runco VX-60d Especificaciones
(126 paginas)
(126 paginas)
Proyectores de datos Runco DR-300c Manual de usuario
(36 paginas)
(36 paginas)
Proyectores de datos Runco CL-420 Especificaciones
(72 paginas)
(72 paginas)
Proyectores de datos Runco RS-440LT Especificaciones
(41 paginas)
(41 paginas)
Proyectores de datos Runco VX-8d Especificaciones
(104 paginas)
(104 paginas)
Proyectores de datos Runco VX-2c Guia de preparacion
(36 paginas)
(36 paginas)
Proyectores de datos Runco CL-500 Manual de usuario
(32 paginas)
(32 paginas)
Proyectores de datos Runco XP-103DHD Especificaciones
(126 paginas)
(126 paginas)
Proyectores de datos Runco VX-4000d Especificaciones
(108 paginas)
(108 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales