
Operation
92 D-73d Series Installation/Operation Manual
• SRC 1-7 Keys / SRC 8-14 Keys: Select SRC 1-7 Keys or SRC 8-14 Keys from the
Remote Control menu to assign the source selection buttons to the source inputs on
the Dimension Digital Controller (refer to SRC 1, SRC 2 ... SRC 14 on page 18). By
default, these buttons are assigned as follows:
To change a button assignment, select the corresponding entry in the SRC 1-7 Keys
or SRC 8-14 Keys sub-menu. Then, choose the source input you wish to assign to
that button.
Display Device - Configure: The options in the Display Device - Configure menu
allow you to change the picture orientation, perform lens adjustments or access other,
display-device specific functions.
• Installation – Orientation: Select Picture Orientation from the Display Device -
Configure menu, then select Orientation to change the picture orientation to suit the
method of installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Display Info.: Select Display Info. from the Display Device - Configure menu to see
the projector serial number.
Remote Control Button Default Source Assignment
SRC 1 ... SRC 8
HDMI 1 ... HDMI 8
SRC 9
DisplayPort
SRC 10
Component
SRC 11
HD 1
SRC 12
HD 2
SRC 13
Composite 1
SRC 14
Composite 2
SRC 1 Key
Composite 1
Composite 2
Composite 3
Component
HD 1
HD 2
SCART
HDMI 1
HDMI 2
HDMI 3
HDMI 4
HDMI 5
HDMI 6
HDMI 7
HDMI 8
DisplayPort
Comentarios a estos manuales