
Installation
22 D-73d Series Installation/Operation Manual
3.2
Quick Setup
Table 3-1 gives a quick overview of the D-73d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 23
2 Choose and install a 3D-compatible screen 24
3 Install CineWide lens mounting assembly (stationary
base plate or AutoScope lens motor – optional)
31
4 Mount the projector 36
5 Mount the Dimension Digital Controller 37
6 Connect the Dimension Digital Controller to the projector 38
7 Connect other external equipment to the Dimension
Digital Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable
screens or screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
40
8 Connect signal sources to the Dimension Digital
Controller
45
9 Connect system components to AC power 50
10 Power up the system and perform optical alignment
procedures (refer to Table 3-6)
51
11 Display calibration —Dimension Digital Controller:
adjust the following for each input and display mode (res-
olution and frame rate); save settings when finished:
• Aspect ratio
•Brightness
• Contrast
• Color level
•Tint
• Sharpness
• White Balance
68
Comentarios a estos manuales