
Installation
D-73d Series Installation/Operation Manual 63
Corner/Midpoint Alignment — 16:9 Aspect Ratio:
1. Select the 16:9 aspect ratio using either the Dimension Digital Controller remote
control unit (see Figure 2-6) or the OSD menu (press MENU, then select Aspect
Ratio -> 16:9). This should move the anamorphic lenses out of the optical path.
2. On the Dimension Digital Controller remote control or front panel, press MENU.
3. Select Calibration from the Main Menu.
4. Select Adjustment Mode from the Calibration Menu and set it to Secondary.
5. Select Image Alignment from the Calibration Menu.
6. Select Corner Alignment to correct a “keystoned” image by adjusting the image
corner positions. Select Midpoint Alignment to correct pincushion distortion by
adjusting the image edge mid-points. See Figure 3-29.
Figure 3-29. Image Alignment Controls
This procedure is normally performed only on the right
(secondary) optical engine.
Use the built-in test pattern when adjusting the image corners or
midpoints. To access it, check the Secondary (or Primary) Test
Pattern box in the Corner Alignment or Midpoint Alignment menu.
Top Left (x, y)
Left
Middle (x)
Left/Right
Middle (y)
Right
Middl
(x)
Bottom Left (x, y)
Top Right (x, y)
Bottom Right (x, y)
Top/Bottom Middle (x)
Top Middle (y)
Bottom Middle (y)
Notes:
1. Smaller “x” values move a point to the left; larger values move it to the right.
2. Smaller “y” values move a point up; larger values move it down.
Center
(x, y)
Comentarios a estos manuales