Runco REFLECTION CL-510 Especificaciones descargar pdf (Pagina 106)

Maintenance and Troubleshooting

94 Runco SC-1 Owner’s Operating Manual

PRE

IMINAR

14. Check Leads: Make sure that the anode (+) lead between lamp and igniter is well

away from any projector metal such as the reflector or firewall.

15. Close the inner lamp cooling compartment door and turn the knob clockwise to

secure it.

16. Replace the lamp/air filter cover and tighten the screw to secure it.

17. Re-attach the AC power cord to the projector.

18. If the new lamp is the same size as the replaced lamp, continue with Step 19.

Otherwise, specify the new lamp size; refer to Defining the Installed Lamp Size on

page 44.

19. Turn the projector back on. Allow the projector and lamp to warm up for

approximately 10 minutes before continuing.

20. Adjust Lamp Position: Perform the steps listed in Maximizing Light Output on

page 46.

Record the New Lamp Serial Number:

21. Press MENU on the projector remote control (Figure 3-29) or control panel

(Figure 2-3).

22. Select Lamp from the Main Menu.

23. Select Change Lamp from the Lamp menu.

24. Enter the serial number in the Lamp S/N text box using the remote numeric keypad.

25. Press ENTER to accept the change. This adds the new lamp serial number to the

Lamp History menu and resets the Lamp Hours timer to “0.” Lamp Mode and Lamp

Limit remain as they were for the previous lamp and can be changed at any time.

Figure 5-4. Recording the Serial Number of a New Lamp

Leads too close to metal parts will cause arcing during starting

pulse. This is a SAFETY HAZARD, and the lamp may not ignite.

WARNING

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 125 126

Sin comentarios

Runco REFLECTION CL-510 Especificaciones Pagina 106