Runco REFLECTION CL-510 Especificaciones descargar pdf (Pagina 56)

Installation

44 Runco SC-1 Owner’s Operating Manual

PRE

IMINAR

3.8

Turning on the Power

Before powering up the projector and igniting the lamp, you must define in memory which

size lamp is installed, otherwise you risk severely over-driving or under-driving a lamp.

Defining the Installed

Lamp Size

1. Press MENU. The Status Display at the top of the projector will show a “Lamp Size” of

2000, 3000, 4500 or 6000 watts. See

Figure 3-24.

Figure 3-24. Checking or Setting Lamp Size

2. Enter the Lamp Password or the Runco service password. (You must enter a

password unless the “Enable Password” service option has been turned off.)

3. Press or to select 2000, if a different lamp size is shown.

4. When the Status Display shows the correct lamp type, you can turn on the projector

and lamp.

Explosion hazard. DO NOT turn the projector on until you have

defined the lamp size.

WARNING

➤

The Lamp Size can also be changed in the Service menu (Service

password required) if the projector is running, but the change will not

take effect until the next power-up. Whenever possible, define the

lamp size before igniting the lamp.

2000

on TheaterMaster

remote keypad

Note: You must enter a password unless the “Enable Password” service option

has been turned off.

Note

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 125 126

Sin comentarios

Runco REFLECTION CL-510 Especificaciones Pagina 56