Runco REFLECTION CL-510 Especificaciones descargar pdf (Pagina 39)

Installation

Runco SC-1 Owner’s Operating Manual 27

PRE

IMINAR

Before installing the projector lamp, check the lamp cradle (anode end) location and adjust

as necessary; see

Figure 3-7. For a 2.0-kW lamp, move the cradle to the rear position,

approximately 1” closer to the reflector.

Figure 3-7. Lamp Cradle Adjustment

To complete the lamp installation, refer to Lamp and Filter Replacement on page 91 for

detailed instructions. Observe all warnings, and wear protective clothing and shielding.

Liquid CoolingDuring operation, a closed loop of flexible tubing circulates liquid coolant from a small

reservoir to critical electronic components located near the front of the projection head.

The coolant (a 50/50 mix of distilled water and ethylene glycol) should fill slightly more than

half of the reservoir to ensure adequate circulation. The reservoir, which is located in the

igniter compartment, is factory-filled and does not require draining for transit. Check the

coolant level regularly.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 125 126

Sin comentarios

Runco REFLECTION CL-510 Especificaciones Pagina 39