Runco REFLECTION CL-510 Especificaciones descargar pdf (Pagina 43)

Installation

Runco SC-1 Owner’s Operating Manual 31

PRE

IMINAR

3.6

Mounting the SC-1

Mount the SC-1 on a strong supporting structure or cart. Carts can be useful when

moving a projector during a presentation or from site to site. If possible, lock the wheels

when it’s in position to prevent it from being moved during a presentation.

Take special care if using a mobile cart; avoid sudden stops, force and uneven surfaces

that may cause the top-heavy cart to lurch and overturn. Make sure your mounting

structure is reasonably level, then adjust one or more projector feet as necessary to

fine-tune.

Adjusting the FeetFor installations on a floor or suitable supporting structure, a single projection head should

rest firmly on its feet. To adjust the height and level of the projector, extend or retract the

feet by rotating them using a crescent wrench; see

Figure 3-9.

Tilting the ProjectorYou can tilt the front end of the projector up or down as much as 15 degrees. Likewise,

you can tilt it side-to-side up to 15 degrees. This limit ensures safe lamp operation and

proper position of the liquid cooling reservoir in the projector. See

Figure 3-12.

Figure 3-12. Tilt Ranges (Front-to-Back and Side-to-Side)

Do not attempt to invert or ceiling-mount the SC-1.

WARNING

Tilt only as shown, and only if absolutely necessary.

WARNING

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 125 126

Sin comentarios

Runco REFLECTION CL-510 Especificaciones Pagina 43