Runco REFLECTION CL-510 Especificaciones Pagina 112

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 111
Maintenance and Troubleshooting
100 Runco SC-1 Owner’s Operating Manual
PRE
L
IMINAR
Y
Panel Driver and Formatter
80 Unrecognized IRAM (panel driver).
81 Unable to program device on IRAM.
82 TI flash download failure.
83 TI flash download fault; partial success.
84 TI flash download fault; partial success.
85 TI-I2C write failure.
87 Consecutive faults from modular Formatters.
90 Red modular Formatter communication failure.
91 Green modular Formatter communication failure.
92 Blue modular Formatter communication failure.
93 Modular formatter architecture error.
94 Modular formatter/DMD mismatch.
95 Modular formatter sequence mismatch.
96 EFIB not responding to I2C messages.
Miscellaneous
A0 Unable to program the optional interface module.
A1 Unable to power the optional interface module.
A2 Unable to program the Dual Slot Backplane Module (DSBP).
A3 Unable to program the optional Post Processing Module (Warp module).
Table 5-2. SC-1 Error Codes (continued)
Code Description
Note: To clear a system error, press the EXIT key (on the SC-1 control panel) twice. If necessary,
reset the projector by powering it off, allowing it to cool and powering it on again. Contact your
Runco dealer or Runco technical support if the error persists.
Vista de pagina 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 125 126

Comentarios a estos manuales

Sin comentarios