Runco REFLECTION CL-510 Especificaciones descargar pdf (Pagina 77)

Installation

Runco SC-1 Owner’s Operating Manual 65

PRE

IMINAR

• Peak Detector: The Peak Detector is a tool to assist with defining individual input

levels, enabling you to accurately set the white balance for any particular source with

the appropriate image.

Enabling the Peak Detector activates a special operating mode for detecting only pixels

that are considered black or white; all other levels are displayed as a mid-level gray.

When used with a smooth grayscale pattern in which black and white are known to be

at opposite edges of the image, you can watch these isolated areas while adjusting

individual black and white levels until both black and white edges are just visible and

distinguished from neighboring pixels. Images from this source will then display correct

blacks and whites without crushing.

Figure 3-33. Adjus ting Black Levels and White Levels Using the Peak Detector

1. Display a 16-level grayscale test pattern from the DHD Controller.

2. Enter a checkmark in the Clipping Detector checkbox.

3. Display one primary color.

4. For the current color, adjust its corresponding “Black Level” slidebar just until a single

band of black appears at one edge of the screen. This band represents the first band of

the grayscale pattern, which should be 100% black. Do not adjust too far.

5. With the same color still active, adjust its corresponding “White Level” slidebar just until

a single band of color appears at the opposite edge of the screen. This band

represents the last band of the grayscale pattern, which should be 100% white (or the

current color, if a certain color is enabled). Do not adjust too far.

The Clipping Detector will initially render the grayscale as a uniform

gray field before adjustment or extreme crushing.

Selecting Auto Color Enable ensures that the correct color is

displayed for each setting.

4. Adjust corresponding

black level (red, green or

or blue) until one black

band appears.

5. Adjust corresponding

white level (red, green or

or blue) until one bright

band appears.

3. Choose one primary

color at a time.

1. Auto Input Level

2. Red (Pr) Blacklevel 256

3. Red (Pr) Input Drive 256

4. Green (Y) Blacklevel 256

5. Green (Y) Input Drive 256

6. Blue (Pb) Blacklevel 256

7. Blue (Pb) Input Drive 256

8. Auto Color Enable

9. Clamp Location Back Porch

0. Peak Detector

Color Enable Red

Input Levels

Note

Tip

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 125 126

Comentarios a estos manuales

Sin comentarios

Runco REFLECTION CL-510 Especificaciones Pagina 77

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores de datos Runco REFLECTION CL-510