Runco 3Dimension D-113d Especificaciones descargar pdf (Pagina 101)

Operation

D-113d Projection System Installation/Operation Manual 85

PRE

IMINAR

Adjustment Mode: By default, any command or control message you send using the

remote control, front-panel keypad or RS-232 interface is acted upon by both the Primary

and Secondary DHD Controllers. In some cases — for example, when using the lens

controls or aligning the “left eye” or “right eye” output images — you may need to address

a command to only the Primary or Secondary DHD Controller. To do this, select

Adjustment Mode from the Calibration menu and set it to Primary or Secondary. The

Main Menu title changes to “Runco Video (Pri.)” or “Runco Video (Sec.)” when you do this.

Splash Configure: Use the Splash Configure menu to control the appearance and

behavior of the “splash” screen that appears on the display upon power-up.

•Owner Name/ISF Calibrated/ISF Other: You can have the D-113d display the

owner’s name, your name, the phrase “ISF Calibrated” and/or any other string, up to

30 characters in length.

Use the up or down cursor button to select a character. Use the right and left cursor

buttons to change the cursor position. Press MENU when you have finished entering

text.

• Splash Timer: When you turn on the D-113d, it projects a welcome screen with the

Runco and ISF logos, along with the personalized information you enter as described

above. Select Splash Timer from the Splash Configure menu to set the amount of time

for which this screen appears. The range is from 5 to 60 seconds, in one-second

increments. Press or to set the timer, then press MENU.

• Splash Enable: When you have finished customizing the splash screen, select Splash

Enable from the Splash Configure menu. Then, select On and press ENTER.

OSD Position: To adjust the position of the OSD, select OSD Position from the

Calibration menu and press ENTER.

Press or to select “Hor.” or “Ver.” Then, press or to change the position.

Lens controls are not available when the Adjustment Mode is set to

Both.

Note

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 151 152

Sin comentarios

Runco 3Dimension D-113d Especificaciones Pagina 101