Runco 3Dimension D-113d Especificaciones descargar pdf (Pagina 69)

Installation

D-113d Projection System Installation/Operation Manual 53

PRE

IMINAR

11. Adjust Position of Left (Top) Primary Lens: To change the lens position, use the

cursor buttons to highlight “Left,” “Right,” “Up” or “Down” in the Lens menu. Then,

press and hold the ENTER button to shift the lens in that direction.

To return the lens to its home position (no horizontal or vertical shift), use the cursor

buttons to highlight “Home” in the Lens menu. Then, press the ENTER button.

12. Remove the cover from the Right (bottom) primary lens and place it on the Left (top)

projector lens.

Right (Bottom) Primary Lens Adjustment:

1. On the DHD Controller remote control or front panel, press MENU.

2. Select Calibration from the Main Menu.

3. Select Adjustment Mode from the Calibration Menu and set it to Secondary.

4. Press EXIT (or MENU) repeatedly to return to the Main Menu.

5. Select Service from the Main Menu.

6. Perform Steps 6 through 11 above with the right (bottom) primary lens.

When you have completed the primary lens adjustments (D-113d/CineWide with

AutoScope only): Set the lens transport motor power switch to the “on” position.

Adjusting the Picture

Orientation

By default, the D-113d is configured for a “floor/front” installation, in which the projector is

installed upright and in front of the screen. If it is installed behind the screen, you must

change the picture orientation. To do this:

1. On the DHD Controller remote control or front panel, press MENU.

2. Select Service from the Main Menu and enter the Service Menu passcode.

3. Select Display Device from the Service Menu.

4. Select Configure from the Display Device menu, then select Installation.

5. Select Orientation, then choose Floor/Rear.

You must enter a passcode to access the Service menu.

Note

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 151 152

Sin comentarios

Runco 3Dimension D-113d Especificaciones Pagina 69