Runco 3Dimension D-113d Especificaciones Pagina 51
- Pagina / 152
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Installation
D-113d Projection System Installation/Operation Manual 35
PRE
L
IMINAR
Y
3.9
System
Interconnections
Proceed as follows to connect the D-113d system components to each other and to AC
power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connecting the Primary
and Secondary DHD
Controllers to the
Projector
Digital Video Connection: Connect the HDMI Out (To Display) connector on the
Primary DHD Controller to the HDMI input on the “left eye” (top) optical engine on the
D-113d projector. Similarly connect the HDMI Out (To Display) connector on the
Secondary DHD Controller to the HDMI input on the “right eye” (bottom) optical engine on
the D-113d projector.
RS-232 Connection: Connect the Display Control output from the Primary DHD
Controller to the RS-232 input on the “left eye” (top) optical engine on the D-113d
projector.
Similarly connect the Display Control output from the Secondary DHD Controller to the
RS-232 input on the “right eye” (bottom) optical engine on the D-113d projector.
Use the provided modular telephone cables with RJ11 plugs at both ends for the RS-232
connections. These cables have color-coded labels at each end to facilitate these
connections. On the D-113d end, use the provided RJ11-to-DB9 adapters. These
adapters are wired as shown in Figure 3-10.
Figure 3-10. RS-232 Connection from the Primary DHD Controller to the
Projector
1
PWR
RS232 IN
3
4
XMT DATA
2
3
RCV DATA
2
5
SIG GND
NO CONNECTION
1, 6
1, 4, 6,
7, 8, 9
To/From
DHD
Controller
To/From Projector
6-position
RJ11 Male
DB9 Male
6
1
1
6
- 3Dimension™ Series 1
- Warranty 3
- Important Safety Instructions 7
- Compliance Information 9
- Table of Contents 11
- List of Figures 15
- 1. Introduction 17
- Using This Manual 18
- Description, Features 19
- Introduction 20
- 3Dimension Processor: 21
- 2. System Overview 23
- Projector 24
- D-113d Input Panel 25
- System Overview 26
- Primary DHD 27
- Controller 27
- Secondary DHD 31
- Remote Control Unit 34
- 3. Installation 37
- Quick Setup 38
- Installation 39
- Considerations 39
- Estimating Throw Distance 40
- Throw Distance (TD) = 40
- 7RGG/RH 44
- Installing the Optional 45
- CineWide with 45
- AutoScope Lens 45
- Assembling the 46
- Projection System 46
- Mounting the D-113d 48
- Installing the Primary 48
- Projection Lenses 48
- Security 49
- Mounting the DHD 50
- Controllers and 50
- Interconnections 51
- Primary DHD Controller 53
- Secondary 53
- 3Dimension 53
- Processor 53
- Audio Processor/ 55
- Switcher 55
- Secondary Display 55
- Control System 56
- AutoScope Lens Motor 57
- IR Sensor 58
- IR Repeater 58
- Remote Control 58
- Power-Up Sequence 65
- Procedure 65
- 16:9/1 1080i/60 68
- Anamorphic Lens (Top View) 75
- Working With the 76
- 4. Operation 77
- Chroma Delay 78
- 4:3 Image on 81
- 16:9 Display 81
- (Letterbox aspect ratio) 81
- 1080i HDTV Image 82
- 720p HDTV Image 82
- Below Black 84
- 3D Processing 90
- Reverse Eyes 90
- 7 Auto Color Enable 96
- 7 Test Pattern Enable 96
- Operation 101
- Lamp Compartment Cover 113
- Retaining Screws 113
- Troubleshooting Tips 115
- 6. External Control 119
- External Control 120
- Table 6-1. Serial Commands 121
- DBO R/W Yes -100 100 No 123
- DGO R/W Yes -100 100 No 123
- DRO R/W Yes -100 100 No 123
- (FCS+) or (FCS-) = Start; 125
- (FCS=0) = Stop 125
- IBO R/W Yes -32 32 No 126
- IGO R/W Yes -32 32 No 127
- IRO R/W Yes -32 32 No 127
- (VSH+) or (VSH-) = Start; 133
- (VSH=0) = Stop 133
- (ZOM+) or (ZOM-) = Start; 133
- (ZOM=0) = Stop 133
- Using Discrete IR 134
- Start Bits Toggle Bit 135
- Address Bits Command Bits 135
- 11010001000001 135
- Using HDMI CEC 138
- Messages 138
- 7. Specifications 141
- DHD Controller 143
- Specifications 143
- 3Dimension Processor 144
- D-113d Dimensions 145
- AutoScope Assembly 146
- Supported Timings 147
- 020-1165-00 Rev. A 152
- October 2011 152
Relacionado con productos y manuales para Proyectores de datos Runco 3Dimension D-113d
Proyectores de datos Runco VX-1000d Especificaciones
(29 paginas)
(29 paginas)
Proyectores de datos Runco RS-440LT Especificaciones
(84 paginas)
(84 paginas)
Proyectores de datos Runco VX-2i Especificaciones
(60 paginas)
(60 paginas)
Proyectores de datos Runco 1080P Especificaciones
(92 paginas)
(92 paginas)
Proyectores de datos Runco D-73d Ultra Especificaciones
(152 paginas)
(152 paginas)
Proyectores de datos Runco CL-410 Especificaciones
(57 paginas)
(57 paginas)
Proyectores de datos Runco VX-1000d Especificaciones
(90 paginas)
(90 paginas)
Proyectores de datos Runco CL-610LT Especificaciones
(56 paginas)
(56 paginas)
Proyectores de datos Runco VX-8d Especificaciones
(88 paginas)
(88 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.196 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales