Runco 3Dimension D-113d Especificaciones Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
Installation
D-113d Projection System Installation/Operation Manual 29
PRE
L
IMINAR
Y
3.4
Installing the Optional
CineWide with
AutoScope Lens
Motors
If you are installing a D-113d/CineWide with AutoScope, proceed as follows to install the
lens mount/motor assemblies on the top and bottom projection units.
1. Carefully unpack the top and bottom projection units.
2. Place the top projection unit (the one with the cosmetic caps on the top) upside down
on a smooth, flat surface covered with a blanket or other soft material.
3. Line up the eight mounting holes on the lens motor housing with those on the bottom
of the top projection unit. Secure the motor to it with the eight screws provided for this
purpose. See Figure 3-6.
Figure 3-6. Attaching the AutoScope Lens Motor to the Projection Unit
Your D-113d/CineWide with AutoScope may have shipped with the
AutoScope lens motors pre-installed. If so — or if you are installing
a standard D-113d (without an anamorphic lens) — skip this step
and proceed with Assembling the Projection System (page 30).
1. Do not install the CineWide lens yet, only the AutoScope lens
motor. You will install the CineWide lens after you install the
projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
Note
Note
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 151 152

Comentarios a estos manuales

Sin comentarios