
System Overview
10 D-113d Projection System Installation/Operation Manual
PRE
L
IMINAR
Y
1. GPIO
Not used.
2. RS232 IN
Connect the RS-232 output from the DHD Controller here, using the provided
RJ11-to-DB9 adapter and communication cable.
3. PWR LED
Lights green to indicate that power is applied and the HDMI input module is initialized.
During normal operation, always on.
4. 1 - HDMI Input
HDCP-compliant digital video input. Connect the HDMI output from the DHD
Controller to this input (see Figure 2-5).
5. 1 LED
Lights green to indicate that a valid digital signal from the DHD Controller is present.
6. 2 - HDMI Input
Not used.
7. 2 LED
Not used; always off.
8. MAIN POWER SWITCH
Disconnects or applies power to the D-113d.
9. POWER INPUT (100 to 240 VAC)
Connect the projector to power here.
Use ONLY the AC power cord shipped with the D-113d for
this purpose (the one with the ferrite sleeve). Doing
otherwise creates a fire hazard risk.
WARNING
Comentarios a estos manuales