
Installation
40 D-113d Projection System Installation/Operation Manual
PRE
L
IMINAR
Y
Additional Connections to
the Primary DHD
Controller (Optional)
The DHD Controller provides the following interfaces to external equipment that allow it to
control or be controlled by that equipment:
• An RS-232 interface to a PC or control/automation system;
• Three (3), 12-volt trigger outputs;
• An infrared (IR) repeater input;
• An Ethernet network interface for firmware updates and maintenance notifications.
The following sections describe how to make these interface connections.
RS-232 Controller Connection: Use a straight-through, 9-pin RS-232 cable to connect
a PC or control/automation system (if present) to the RS-232 port on the DHD Controller;
see Figure 3-14.
Figure 3-14. RS-232 Control System Connection to Primary DHD Controller
To Accessory Box
PC / Control
RS-232
IR
Display Control
HDMI 3
HDMI 4
Ethernet
HDMI Out
To Display
HDMI Out
Audio Only
RS-232
T
Accessor
Bo
Display Contro
t
rn
MI Ou
To Dis
l
HDMI
Audio
nl
R
-232
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Receive Data
3 Transmit Data
5 Ground
(none of the other pins are used)
Comentarios a estos manuales